Pontiac Radio Control/Display Board +bulbs (2000+ CD)
HOURS
9am-5pm M-F CST
(Effingham, IL)
Pontiac Radio Control/Display Board +bulbs (2000+ CD) PHONE
877-479-1633
(Toll Free)
  Home » Radio Parts » GM » Other » Pontiac Radio Control-Display Board +bulbs (2000+ CD) My Account  |  Cart Contents  |  Checkout  |  All Products  
Categories
Specials more
GM 2010+ Denso navigation radio 100GB Toshiba HDD hard drive NEW
GM 2010+ Denso navigation radio 100GB Toshiba HDD hard drive NEW
$50.00
$15.00

View All Discount Products
What's New? more
Sorento 2015+ RH passenger side BSM mirror w/o cover NEW
Sorento 2015+ RH passenger side BSM mirror w/o cover NEW
$139.99

View Latest Additions

Pontiac Radio Control-Display Board +bulbs (2000+ CD): GM Delco
[P04CDB]

$85.00

  Free Shipping in the Continental US via standard ground service

This is a new Pontiac CD radio control/display board. You would use this if you have lights out in your radio display or behind the buttons. It works on the CD and CD/Cass radios. (It is just missing the bulb for the cassette eject button.) This is not for CD6 radios. If yours looks the same or very similiar to the radio pictured below, this will work for you. (It works for the am/fm/cd with black buttons too.) This board has all new bulbs behind the buttons and behind the display panel.

This does NOT include the face with all the buttons. You are getting the control/display board behind it ONLY. The face is shown only for illustrative purposes only, to make sure you know which radio the board is for.

Please note that this version does not have the light behind the cassette eject button. This has no bearing on functionality of the buttons.


INSTALL ADVICE


    Installation is pretty easy. The very first thing you MUST do is unplug the radio from the vehicle or disconnect the negative battery terminal and let the radio sit for at least 30 minutes!! To dis-assemble it, you will need a regular screwdriver to remove the bottom plate, a 3/16 nut driver to remove the cassette drive (if applicable) and a 1/8 nut driver to remove the display/control board from your face. You need to disconnect both plugs for the board BEFORE removing the face. They are both under the bottom plate, under the cassette drive (if applicable.) You will also have to pull the knobs off the face before removing the screws holding the board to the face. (Make sure the front of the face is pointed down when you do this, as the buttons can fall out the back once the board is off.) Then you will repeat in reverse...






***** For illustration only. Face with buttons is NOT included! *****

***** For illustration only. Face with buttons is NOT included! *****

Current Reviews: 6
This product was last updated on Thursday 15 June, 2023.
UPC:
Click to RECEIVE
 Product Notifications on this item
Product Reviews
Submited By: Terry Bickford on 07/31/2016
Fit perfectly, though the wires on the 10 wire plug where short, causing the end wire to pull out. Lucky I am a technicall person and was able to replace the one wire with one from the old board....

Reply by ReplacementRadios on 8/3/16: We never like to hear of a problem. Even an installation problem on the back end. Please note: these boards are removed from brand new GM radios which we part out, so the plug harnesses ARE long enough to reach the sockets. The problem the customer mentioned only occurs when either the harness is routed incorrectly, the harness is partially stuck behind the face, or the face has not been snapped on completely prior to trying to insert the plug in the socket. Pulling on a harness to stretch it to the plug is not required. If you are trying to insert a plug in your socket and find it does not reach, you should check the three things above. The explanation lies there and, once you correct the problem, it will plug in just fine.

Rating: 4 of 5 Stars!
Submited By: Charles K Spencer on 03/17/2015
This was a very easy install (once I was able to remove the radio!). The Pontiac Vibe/Toyota Matrix is not the easiest car to remove fuses from. The interior fuse box is located tucked up under the lower driver's side dash, and if you're not under 5'5" or so, it's a nightmare to access. I had to remove the driver's seat and stretch out on my back to get underneath. The fuse removal is part of the airbag disabling procedure that the Haynes service manual says to do before working anywhere near the airbags. I seriously recommend purchasing the Haynes Toyota Matrix/Pontiac Vibe manual as it gives step-by-step instructions (and photos) how to safely remove dash bezels and the radio. I did follow the instructions that came with the display board and let the radio sit for an hour before opening the case to remove the old display board. One hint for those of you wishing to repair your own radio - get a set of micro socket wrenches or nut drivers, because the screws that hold the display board to the radio face are about 1mm (or smaller) hex head screws. I did alright using a set of 90 degree angled needle nose pliers by clamping the little screw head in the outer bend of the pliers. After that, I reversed the procedures to put the radio back together and re-installing it in the dash. All-in-all, it took me about 4 hours start to finish, and would have been less if I didn't remove the driver's seat for easy access to the fuse box (not one of Toyota's better ideas). After all that work, I have a radio display that works!!!

Rating: 5 of 5 Stars!
Submited By: Melvin Kubas on 04/20/2014
Super fast shipping, Easy to install. Works like a new radio. thanks guys

Rating: 5 of 5 Stars!
Click to read more
 Reviews on this item Write your own
 review on this product
Average Customer Rating: Displaying 3 of 6 product reviews
5 out of 5
Customers who bought this product also purchased
Pontiac new CD radio face w/ knobs & buttons (2000+ style)
Pontiac new CD radio face w/ knobs & buttons (2000+ style)
Pontiac Bonneville Vibe CD-Cassette radio face (black buttons)
Pontiac Bonneville Vibe CD-Cassette radio face (black buttons)
UPS 2nd Day Air End of Day - Package (Continental US)
UPS 2nd Day Air End of Day - Package (Continental US)
Related Products
Related Categories
Related Manufacturers
Twitter
Pintrest
Google+
Facebook
Shopping Cart more
0 items
Notifications more
Click to RECEIVE
 Product Notifications on this itemNotify me of updates to Pontiac Radio Control-Display Board +bulbs (2000+ CD)
Tell A Friend
 
Tell someone you know about this product.
Search Our Site
 
Using Search: Try make, model and a keyword. (ie- ford explorer mp3) Remove keywords to broaden. (ie- ford mp3) Use double quotes for exact search. (Warning - may exclude some relevant results.)
Follow Us
Facebook Link Twitter Link Pinterest Link Google+ Link
Information
Shipping & Returns
Privacy & Security
About Us
Contact Us
View All Products
Links
Site Map
Show Mobile View more

PayPal-Make fast, easy, and secure payments without giving merchants your credit card info!  Visa  Mastercard  Discover  American Express

Factory radios-Bluetooth kits-iPod adapters-Satellite radio interfaces-USB Android audio-stereo repair + more.

Copyright © 2005 Replacement Radios
Powered by osCommerce

OEM car radios | delco radio | factory car stereos | ford radio | factory radio
car radio repair | grom audio | vais technology | radio repairs | refurbished car stereo
car bluetooth adapter | ipod car adapter | usb car adapter | wireless charging car dock | ipod car adapter
satellite radio for car | iphone car integration | usb car stereo | android car stereo | isimple bluetooth

CLASSIC - MOBILE View