DETAILS

This appears to be called the Upper End Cap Assembly. You would use this if yours is damaged. (By your kids maybe...) This particular one seems to be the Luxury version, based on the sticker adhered to it. It is "Morello Red" leather with suede accents. It came from an assembly line left-over console that was never installed in a car, so it is in very good condition. Minor blemishes or soil from bulk storage, if anything. (The consoles these come from are very cumbersome to store and move around.) Pictures are of one of the actual pieces in our possession. (Yes, we have more than one.)

Installation will require partial disassembly of your console. You will need to pull the lower plastic tail section from your console to access the two screws that hold this Upper End Cap in place. The lower tail is just held on with pressure connectors. (Six, I believe.) If you cannot get your hand under the bottom edge of the lower tail, you will need to use a plastic pry tool to get in from each side and pry the very bottom out. Then you should be able to use your hands to pop the remaining clips loose. Once you remove it, you will find one or two wiring connectors holding it on. It's best to push the pressure tabs on those and remove them from the plugs so you can get the lower tail out of the way. Then you can usually force a philips bit up into the console to get at the two screws (one on each end) that hold the Upper Cap in place. (We're able to here anyway.) If not, you can either use a dremel to remove some of the plastic material keeping you from getting a straight shot at the screws or you can remove the whole console lid to gain access to the screws. If you want to do the latter and need instructions, please let us know.

We have other parts for this console available too. Just drop us a message and we'll set up a special listing for you.