Options

Saab 97X 2005-2009 Radio Control-Display Board +bulbs

Saab 97X 2005-2009 Radio Control-Display Board +bulbs
[S9CDnb]

Saab 97X 2005-2009 Radio Control-Display Board +bulbs
$20.00

SUMMARY


  • BRAND NEW Factory (OEM) GM radio control/display board
  • Includes all the bulbs, in brand new condition
  • Includes all the connectors, so it's Plug-n-Play!!
  • Works on single CD radios only
  • Looks EXACTLY like the one pictured.  (You get what you see.)
  • A GREAT way to replace a board with bad bulbs or volume, tune or audio controllers.
  • NOT compatible with the CD6 radio (am/fm radio with built-in 6 CD changer)
  • Fully compatible with BOSE or non-BOSE radios
  • Will NOT trigger the THEFTLOCK system (Plug your radio back in and go.)
  • Has NEVER been in a vehicle!!
  • Will require removal of your radio from the vehicle (Do not attempt with radio connected)
  • Available with the face in one of our other listings

APPLICATIONS
  • Saab 9-7X: 2005-2009

This does NOT work for any vehicles not mentioned.  Please don't assume that, just because it looks like the truck/suv board, it will work.  It's different.  Some of the parts may be the same but it is NOT a direct swap!! If in doubt, pull your volume or tune knob off the radio. If you have a skinny metal shaft behind it, this is the right board for you. If you have a large plastic shaft, this is NOT the right board. You need the truck/suv board. Returns are not accepted, so you need to make sure you've read this ad and have checked everything BEFORE ordering.


ADDITIONAL INFO
Assembly is pretty easy. You will only need a regular screwdriver to remove the top and bottom plates, a 3/16 nut driver to remove the cassette drive (if applicable) and a 1/8 nut driver to remove the display/control board from your face. You need to disconnect all three plugs for the board BEFORE removing the face. One is under the top plate and two are under the bottom plate, under the cassette drive (if applicable.) You should also remove the radio from the vehicle or disconnect the negative battery terminal for at least 30 minutes prior to beginning this process.

This product was last updated on Monday 09 September, 2019.