• New Old Stock factory (OEM) CD drive
• Has NEVER been in a vehicle!!
• Works in most am/fm single CD radios
• Looks like the one pictured above. (Match it to yours!)
• Addresses most load, eject and playback issues
• NOT compatible with the CD6 radio (built-in 6 CD changer)
• Not compatible with navigation radios
• Plays standard audio format CDs and CDRs
• Plays MP3 audio format CDRs (but only if your current drive does)
• Fully compatible with Infinity or non-Infinity single CD radios
• Requires removal of radio from the vehicle (Do not attempt with radio connected)
• Requires re-using your control board
• Returns not accepted unless there is a functional defect (See details below)
• 6 month warranty

---

APPLICATION CHART

---

According to our info, this drive was offered in some of the following vehicles. However, in some models/years, multiple drive types were used. We have provided a picture. It is up to you to confirm it is the same one you have in your vehicle. You can usually do this by popping the top over off the radio so you can see the top of the drive. (Other versions looked drastically different.)

• Santa Fe: 2007-2008

---

ADDITIONAL INFO

---

Make sure to confirm this is the drive you have BEFORE ordering. Compare your drive (not your radio) to the picture.

Assembly is pretty easy. You will need a flat screwdriver to remove the top plate and, possibly, the face, as well as a 3/16 nut driver to remove the old drive. Then you will swap the control board from the bottom of yours to this one. That is usually just a couple quick connect cables and a couple small phillips-head screws. Do not attempt this repair with the radio still plugged in!