Radios with this same basic board were offered in the cars and mini-vans from 2000 up. If you have a car or minivan and your radio looks like one of the following, this should work for you.
This does NOT work for any vehicles not mentioned. Please don't assume that, just because it looks like the truck/suv board, it will work. It's different. Some of the parts may be the same but it is NOT a direct swap!! If in doubt, pull your volume or tune knob off the radio. If you have a skinny metal shaft behind it, this is the right board for you. If you have a large plastic shaft, this is NOT the right board. You need the truck/suv board. Returns are not accepted, so you need to make sure you've read this ad and have checked everything BEFORE ordering.
A list of radio part numbers this is known to work for appears below this application chart.
- Chevrolet Blazer (S10): 2002*-2003
- Chevrolet Cavalier: 2003-2005
- Chevrolet Express: 2000-2002
- Chevrolet Impala: 2000-2005
- Chevrolet Malibu: 2000-2003
- Chevrolet Monte Carlo: 2000-2005
- Chevrolet S10: 2002*-2003
- Chevrolet Trailblazer: 2002*-2003
- Chevrolet Venture: 2000-2005
- GMC Envoy: 2002*-2003
- GMC Jimmy: 2002*-2003
- GMC S15: 2002*-2003
- GMC Savana: 2000-2002
- GMC Sonoma: 2002*-2003
- Oldsmobile Silhouette: 2000-2005
*Some 2002 vehicles still had the older style of radio. Make sure yours matches one of those pictured in this listing.
This board is known to work on the following radio part numbers. CD/Cassette: 09379071, 09394159, 10318438, 10324041, 10335226, 10346320, 15058225, 15091317, 15169582, 15195517 and 15195518. CD: 10318434, 10324040, 10335223, 10346316, 15058230, 15091316, 15169545 and 15195521. There are several other part numbers too. If your vehicle is on the list above and your radio looks like this, it should work for you. If you are still concerned and want to make sure it's right for you, you can email us your radio part number and we will check. It is on a sticker on the side of the radio. Alternatively, a GM dealer can look it up for you using your VIN.
ADDITIONAL INFO
Assembly is pretty easy. You will only need a regular screwdriver to remove the top and bottom plates, a 3/16 nut driver to remove the cassette drive (if applicable) and a 1/8 nut driver to remove the display/control board from your face. You need to disconnect all three plugs for the board BEFORE removing the face. One is under the top plate and two are under the bottom plate, under the cassette drive (if applicable.) You should also remove the radio from the vehicle or disconnect the negative battery terminal for at least 30 minutes prior to beginning this process.
